I have multiple sensors, how can I distinguish them?

• Sometimes, if you have multiple MOCREO sensors, you may have difficulty in distinguishing the sensors in the app. Perhaps they were stored together without being labeled during the setup process, or they are confusing. Each sensor has its own device ID, but it is stored electronically on the device. The device itself does not have a unique physical identifier or label (SW2, ST5 have MACID to distinguish the device). However, using the app it is easy to identify the sensor:

Tip

After binding the sensor successfully, you can use a pushpin to poke the sensor’s pinhole. The corresponding sensor card on the app’s homepage will blink once within 5s-10s.