Climate Sensor - ST6

1. Open the app, click the “Add Device” button in the top right corner of the screen, and select Climate Sensor - add ST6. (If prompted to bind the Hub, please refer to How to Bind Hub by clicking here )

2. Use a pin to poke the sensor’s pinhole, and wait until the sensor’s blue status light starts flashing.

3. Follow the setup prompts on the screen to set up the sensor. (Up to 10 sensors can be added at once).

4. After successful setup, click “Home” to return to the homepage, and the sensor card you just set up should appear.

I have tried, but the binding was not successful, what should I do?

I’m really sorry for the trouble it’s causing you. However, the following steps can solve your doubts:

• Turn off Bluetooth in your phone settings, wait for a moment, and then turn it on again.

• Ensure that your phone can connect to the network with the Hub.

• When the mobile device scans the sensor, make sure the sensor’s status light is flashing, so the mobile device can scan the sensor.

If you still have any problems, please contact us(contact@mocreo.com) for more help.